Proper use of a bore sight ?

O

OPAH

Active Member
OK a couple more days, and I will swap my scope from my BOSS to My BAR, now I don't want to waste a shit load of ammo so I plane to use a red dot laser bore sight.
Now I plan to match the dots as far a I can see the bore sight laser, is that correct ? Or is there a specific distance ? 10 foot equates to 100 yards ?
 
OPAH said:
OK a couple more days, and I will swap my scope from my BOSS to My BAR, now I don't want to waste a shit load of ammo so I plane to use a red dot laser bore sight.
Now I plan to match the dots as far a I can see the bore sight laser, is that correct ? Or is there a specific distance ? 10 foot equates to 100 yards ?
Click to expand...

The laser in my experience will get you on paper, you will definitely need to adjust elevation at the range though.
 
Mine is not red dot, it shows actual target with 1" graduation. Tapered expanding rod goes in bore and target mounts on it. Mine is set for sighting at 100 yards. Like mention it will get you close.
 
just zero the scope to the dot at 50 yards. that tends to be the spot the bullet as its moving up crosses plane of the scope.

or just remove the bolt. Look down the tube, adjust scope to be in the same spot and go shoot...
 
Point it in the deer’s eyes and bludgeon them to death with the stock while they’re blinded.

Make sure you yell “zap zap” when you do it, it makes the laser work better.
 
Come on now, how do I get this BBAR close to start ?
Cant blow a bunch of rounds Now. If I can Havve it on paper the first 3 rounds i can have it grouper and zeroed in 12 rounds, I want it to Be as lose to clover by 20 rounds.
And I prefer BANG BANG to Zap Zap
 
Last edited:
You must log in or register to reply here.
Back
Top