I have 2 hides I already tanned and never got around to breaking. So they are dry and stiff. These are NOT for capes/mounts.
I had purchased some Neet's Foot Oil, for the purpose of breaking/softening the hides.
I've read different things about how to proceed at this point. If you know anything about this process, chime-in and tell me what's right to do and what's wrong to do or not needed. OR additional steps they've left out?
What I've gathered so far:
Use a spray bottle and mist the hide to let it re-hydrate a little and soak-in with that spritz of water for like an Hour, in order for it to THEN be able to take in the oil in a brushed-on 50/50 solution of oil-water (lukewarm water) afterward.
Let this soak in. As this is drying, but not yet dry and still pliable, do the mechanical/physical steps for breaking/stretching the hide.
Rubbing across some surface (a cable, or a piece of wood, or a PVC pipe opening, or a metal pipe opening) back-and-forth like a shoe-shine. And one guy was using a common wide/thin pry-bar as a tool to push down and outward on the hide away from his holding hand, with it laying down on a bench, looked like probably the best bet for me, at least for doing the edges of the hide anyway)
Then people are saying they go back and sandpaper the hide to really make it soft. And thin-down areas where the leather is thicker like around neck and shoulders.
Sandpaper by hand? Is a Mouse Sander Ok? What grit should I use?
SIDE NOTE: I'm presuming here that a person is going to want to barely use just enough oil to get the job done. I'm assuming slowly, if needed, brush-on another thin amount again and let it soak in some more then repeat the physical/mechanical break-in steps, if you're not achieving good stretching and whitening of the breaking-apart skin fibers during the physical steps, yes?
I had purchased some Neet's Foot Oil, for the purpose of breaking/softening the hides.
I've read different things about how to proceed at this point. If you know anything about this process, chime-in and tell me what's right to do and what's wrong to do or not needed. OR additional steps they've left out?
What I've gathered so far:
Use a spray bottle and mist the hide to let it re-hydrate a little and soak-in with that spritz of water for like an Hour, in order for it to THEN be able to take in the oil in a brushed-on 50/50 solution of oil-water (lukewarm water) afterward.
Let this soak in. As this is drying, but not yet dry and still pliable, do the mechanical/physical steps for breaking/stretching the hide.
Rubbing across some surface (a cable, or a piece of wood, or a PVC pipe opening, or a metal pipe opening) back-and-forth like a shoe-shine. And one guy was using a common wide/thin pry-bar as a tool to push down and outward on the hide away from his holding hand, with it laying down on a bench, looked like probably the best bet for me, at least for doing the edges of the hide anyway)
Then people are saying they go back and sandpaper the hide to really make it soft. And thin-down areas where the leather is thicker like around neck and shoulders.
Sandpaper by hand? Is a Mouse Sander Ok? What grit should I use?
SIDE NOTE: I'm presuming here that a person is going to want to barely use just enough oil to get the job done. I'm assuming slowly, if needed, brush-on another thin amount again and let it soak in some more then repeat the physical/mechanical break-in steps, if you're not achieving good stretching and whitening of the breaking-apart skin fibers during the physical steps, yes?