Hey guys so I’ve been reloading for a bit now. Still pretty new to it but I’ve worked up some loads for 28 nosler and 204 ruger without many issues. In the past I’ve always lubed cases individually with my fingers with the RCBS dropper. Never had a lube dent. Recently I’ve read quite a few guys saying that they use non stick cooking spray like Pam. Spray it in a bag of brass mix around and go to town. So I gave it a try and it was so much quicker I was the happiest guy in the world. Fast forward about 30 min later when I was pulling the cases from the wet tumbler the cases had tons of small lube dents on em. I should have noticed this while resizing but I felt no resistance and the cases didn’t seem overly lubed so I didn’t even pay attention. I know they will fire out but I was all pumped on the efficiency of this and a super disappointed in the results.
So my question is, If anyone uses the cooking spray method do you have any pointers you could offer? Or any other quicker method of efficiently lubing cases.
Also, will a case with a dent effect accuracy? For average shooting I wouldn’t be worried. But I was going to use this brass to work up a new lead free load so accuracy is even more important than usual.
So my question is, If anyone uses the cooking spray method do you have any pointers you could offer? Or any other quicker method of efficiently lubing cases.
Also, will a case with a dent effect accuracy? For average shooting I wouldn’t be worried. But I was going to use this brass to work up a new lead free load so accuracy is even more important than usual.